All the names being tossed around for the parts of the tagger were finally committed to an image which explicitly named each piece. This was important for the instructions being created at HackaDay.io so anyone following them knows which part is being referred.
A similar diagram was made for the lens focusing parts inside the forward array. These parts were too small to name on the large diagram and they were hidden inside the other parts.
The first draft of the instructions on HackaDay.io were written. They have not been proof-read and a couple other things need revision but the instructions are nearly finished. Links to the project are good.
Downloads:
The rest of the posts for this project have been arranged by date
First time here?
Completed projects from year 1
Completed projects from year 2
Completed projects from year 3
Disclaimer for http://24hourengineer.blogspot.com/ and 24hourengineer.com
This disclaimer must be intact and whole. This disclaimer must be included if a project is distributed.
All information in this blog, or linked by this blog, are not to be taken as advice or solicitation. Anyone attempting to replicate, in whole or in part, is responsible for the outcome and procedure. Any loss of functionality, money, property or similar, is the responsibility of those involved in the replication.
All digital communication regarding the email address 24hourengineer@gmail.com becomes the intellectual property of Brian McEvoy. Any information contained within these messages may be distributed or retained at the discretion of Brian McEvoy. Any email sent to this address, or any email account owned by Brian McEvoy, cannot be used to claim property or assets.
Comments to the blog may be utilized or erased at the discretion of the owner. No one posting may claim property or assets based on a post.
This blog, including pictures and text, is copyright to Brian McEvoy.
2017-07-18 (Tu)
Labeled tagger parts
A similar diagram was made for the lens focusing parts inside the forward array. These parts were too small to name on the large diagram and they were hidden inside the other parts.
The first draft of the instructions on HackaDay.io were written. They have not been proof-read and a couple other things need revision but the instructions are nearly finished. Links to the project are good.
Scrolling through the HackaDay instructions
Downloads:
- Arduino firmware
- OpenSCAD code
- STL printable models
- STL printable pipe dividers
- Python Last-Man-Standing program
- Gerber files for SMT IR Sensor board
- Gerber files for controller board
- Gerber files for homemade controller board (thicker traces than the previous version)
- Public project page for controller board
- Public project page for sensor board
The rest of the posts for this project have been arranged by date
First time here?
Completed projects from year 1
Completed projects from year 2
Completed projects from year 3
Disclaimer for http://24hourengineer.blogspot.com/ and 24hourengineer.com
This disclaimer must be intact and whole. This disclaimer must be included if a project is distributed.
All information in this blog, or linked by this blog, are not to be taken as advice or solicitation. Anyone attempting to replicate, in whole or in part, is responsible for the outcome and procedure. Any loss of functionality, money, property or similar, is the responsibility of those involved in the replication.
All digital communication regarding the email address 24hourengineer@gmail.com becomes the intellectual property of Brian McEvoy. Any information contained within these messages may be distributed or retained at the discretion of Brian McEvoy. Any email sent to this address, or any email account owned by Brian McEvoy, cannot be used to claim property or assets.
Comments to the blog may be utilized or erased at the discretion of the owner. No one posting may claim property or assets based on a post.
This blog, including pictures and text, is copyright to Brian McEvoy.
2017-07-18 (Tu)
Comments
Post a Comment