A design was created for the screen holder which was no more than a clear plastic cover on the tagger enclosure. A window will be created by spray painting the panel except for the screen area which will be masked off with tape. This adds complication since the the RJ11 phone connector cannot be attached using a keystone (modular) part. Glare resistant acrylic sheeting was purchased to act as the enclosure cover. A switch box cover with two RJ11 sockets was purchased and the sockets were unfastened from the faceplate.
The PVC tagger enclosure had tape applied to the edges to protect it from marking. The outline of the enclosure was traced on to the acrylic sheet. Five outlines were traced but only two will be cut immediately. The mounting holes for the enclosure were also marked by looking through the plastic. Holes were marked for mounting the phone socket but they will likely be glued in place.
To do:
The rest of the posts for this project have been arranged by date.
Wall mount RJ11 unit with one socket removed
The PVC tagger enclosure had tape applied to the edges to protect it from marking. The outline of the enclosure was traced on to the acrylic sheet. Five outlines were traced but only two will be cut immediately. The mounting holes for the enclosure were also marked by looking through the plastic. Holes were marked for mounting the phone socket but they will likely be glued in place.
Tracing with taped enclosure
Marking unnecessary holes
To do:
- Draft schematics
- Break down tasks further
- Create vest mount for controller, battery, and terminal strip
- Build another test unit
- Make instructions for all parts
Journal Page
The rest of the posts for this project have been arranged by date.
A list showing of all the final posts of COMPLETED projects.
Disclaimer for http://24hourengineer.blogspot.com/
This disclaimer must be intact and whole. This disclaimer must be included if a project is distributed.
All
information in this blog, or linked by this blog, are not to be taken
as advice or solicitation. Anyone attempting to replicate, in whole or
in part, is responsible for the outcome and procedure. Any loss of
functionality, money, property or similar, is the responsibility of
those involved in the replication.
All digital communication regarding the email address 24hourengineer@gmail.com becomes
the intellectual property of Brian McEvoy. Any information contained
within these messages may be distributed or retained at the discretion
of Brian McEvoy. Any email sent to this address, or any email account
owned by Brian McEvoy, cannot be used to claim property or assets.
Comments
to the blog may be utilized or erased at the discretion of the owner.
No one posting may claim claim property or assets based on their post.
This blog, including pictures and text, is copyright to Brian McEvoy.
2014-11-13 (Th)
2014-11-13 (Th)
Comments
Post a Comment