2015-02-24 (Tu) Prismatic Stereoscopic Screen Viewer

A simple part was designed to interface with the camera mount. This was a replica of the piece which normally contacts the camera mount but all the dimensions were generated by logical inference. The bottom part of the mount was intended to have a 5mm hole which would be tapped to have threads like those found on a typical (1/4-20) camera mount.

The design was not drawn to scale but measurements shown in green are what will be designed for. One issue may be printing circular holes which could lead to sagging of the print lines. The design should be revised.

Diagram of mount

To do:

• Redesign part for 3D printing
• Create To Do list

The rest of the posts for this project have been arranged by date.

A list showing of all the final posts of COMPLETED projects.

Disclaimer for http://24hourengineer.blogspot.com/

This disclaimer must be intact and whole. This disclaimer must be included if a project is distributed.

All information in this blog, or linked by this blog, are not to be taken as advice or solicitation. Anyone attempting to replicate, in whole or in part, is responsible for the outcome and procedure. Any loss of functionality, money, property or similar, is the responsibility of those involved in the replication.

All digital communication regarding the email address 24hourengineer@gmail.com becomes the intellectual property of Brian McEvoy. Any information contained within these messages may be distributed or retained at the discretion of Brian McEvoy. Any email sent to this address, or any email account owned by Brian McEvoy, cannot be used to claim property or assets.

Comments to the blog may be utilized or erased at the discretion of the owner. No one posting may claim claim property or assets based on their post.

This blog, including pictures and text, is copyright to Brian McEvoy.

2015-02-12 (Th)