A micro USB port was attached purely as a power supply port. Soldered wires on the breakout board broke while testing so a firm mounting location seemed important. Screws were used to mount the USB port for the keyboard but required a standoff and placing the device closer to an edge would have eliminated the need for standoffs. In this case the port was glued to the lid of the enclosure. If any problems arose from this configuration the port and lid could be replaced as a unit and the wires running from the USB port could be taken out of the screw terminals. Since no more testing would be done the curing time of the glue was acceptable while screws or bolts would have been necessary to continue testing.
Construction was nearly completed. An assessment needs to be taken to recognize what problems still need to be addressed. For example: the cord between the emitter-receiver tube is too short.
Downloadable Files:
To do:
Soldered wires on breakout board
Using glue, E6000, on the lid and USB port
Port held to lid for glue to cure
Construction was nearly completed. An assessment needs to be taken to recognize what problems still need to be addressed. For example: the cord between the emitter-receiver tube is too short.
Downloadable Files:
To do:
- Write instructions
- Compress and link to all files
- OpenSCAD files
- STL models
- Arduino code
- Make diagram with every part labeled
- Schematic for servo controller
The rest of the posts for this project have been arranged by date.
First time here?
Completed projects from year 1.
Completed projects from year 2.
Disclaimer for http://24hourengineer.blogspot.com/
This disclaimer must be intact and whole. This disclaimer must be included if a project is distributed.
All information in this blog, or linked by this blog, are not to be taken as advice or solicitation. Anyone attempting to replicate, in whole or in part, is responsible for the outcome and procedure. Any loss of f
functionality, money, property or similar, is the responsibility of those involved in the replication.
All digital communication regarding the email address 24hourengineer@gmail.com becomes the intellectual property of Brian McEvoy. Any information contained within these messages may be distributed or retained at the discretion of Brian McEvoy. Any email sent to this address, or any email account owned by Brian McEvoy, cannot be used to claim property or assets.
Comments to the blog may be utilized or erased at the discretion of the owner. No one posting may claim claim property or assets based on their post.
This blog, including pictures and text, is copyright to Brian McEvoy.
2015-10-21 (W)
First time here?
Completed projects from year 1.
Completed projects from year 2.
Disclaimer for http://24hourengineer.blogspot.com/
This disclaimer must be intact and whole. This disclaimer must be included if a project is distributed.
All information in this blog, or linked by this blog, are not to be taken as advice or solicitation. Anyone attempting to replicate, in whole or in part, is responsible for the outcome and procedure. Any loss of f
functionality, money, property or similar, is the responsibility of those involved in the replication.
All digital communication regarding the email address 24hourengineer@gmail.com becomes the intellectual property of Brian McEvoy. Any information contained within these messages may be distributed or retained at the discretion of Brian McEvoy. Any email sent to this address, or any email account owned by Brian McEvoy, cannot be used to claim property or assets.
Comments to the blog may be utilized or erased at the discretion of the owner. No one posting may claim claim property or assets based on their post.
This blog, including pictures and text, is copyright to Brian McEvoy.
2015-10-21 (W)
Comments
Post a Comment