Shape of the post hole had to be revised again. While the spinner sat on the post it could not reach the magnet due to where the magnets sat which was protected by the post hole. Instead of a cone shape the post hole was modeled to look like a cone on top of a cuboid. This shape is a mix of the first shape which used a small cone on top of large cuboid and yesterday’s shape which was only a large cone.
To do:
First time here?
Completed projects from year 1.
Completed projects from year 2.
New post hole shape
Spinner model
To do:
- Make handheld haptic compass
- Make compass work from pocket or necklace
- Miniaturize
First time here?
Completed projects from year 1.
Completed projects from year 2.
Disclaimer for http://24hourengineer.blogspot.com/
This disclaimer must be intact and whole. This disclaimer must be included if a project is distributed.
All information in this blog, or linked by this blog, are not to be taken as advice or solicitation. Anyone attempting to replicate, in whole or in part, is responsible for the outcome and procedure. Any loss of functionality, money, property or similar, is the responsibility of those involved in the replication.
All digital communication regarding the email address 24hourengineer@gmail.com becomes the intellectual property of Brian McEvoy. Any information contained within these messages may be distributed or retained at the discretion of Brian McEvoy. Any email sent to this address, or any email account owned by Brian McEvoy, cannot be used to claim property or assets.
Comments to the blog may be utilized or erased at the discretion of the owner. No one posting may claim claim property or assets based on their post.
This blog, including pictures and text, is copyright to Brian McEvoy.
2016-01-20 (W)
Comments
Post a Comment