Blue and red wires were soldered to all the outputs which would reside in the front of the tagger. Two LEDs for the flashlight, one red LED for the flash simulator, one red laser module, and one infrared LED.
The wires were all soldered to a small prototyping circuit board so they could be linked to the main board later. This should have been done with a connector or the components could have simply been given long wires. It will be easy enough to remedy this in the next build.
Mounting the laser module was done with glue. Ideally, this would have used a special clip after being inserted into a thin faceplate but glue worked well enough.
No infrared receiver was attached to the front of the tagger but everything else was connected to give an idea of what the tagger will look like from the front.
Downloads:
The rest of the posts for this project have been arranged by date
First time here?
Completed projects from year 1
Completed projects from year 2
Completed projects from year 3
Disclaimer for http://24hourengineer.blogspot.com/ and 24hourengineer.com
This disclaimer must be intact and whole. This disclaimer must be included if a project is distributed.
All information in this blog, or linked by this blog, are not to be taken as advice or solicitation. Anyone attempting to replicate, in whole or in part, is responsible for the outcome and procedure. Any loss of functionality, money, property or similar, is the responsibility of those involved in the replication.
All digital communication regarding the email address 24hourengineer@gmail.com becomes the intellectual property of Brian McEvoy. Any information contained within these messages may be distributed or retained at the discretion of Brian McEvoy. Any email sent to this address, or any email account owned by Brian McEvoy, cannot be used to claim property or assets.
Comments to the blog may be utilized or erased at the discretion of the owner. No one posting may claim property or assets based on a post.
This blog, including pictures and text, is copyright to Brian McEvoy.
2017-05-28 (Su)
Outputs with wires
The wires were all soldered to a small prototyping circuit board so they could be linked to the main board later. This should have been done with a connector or the components could have simply been given long wires. It will be easy enough to remedy this in the next build.
Outputs soldered to a test board
Mounting the laser module was done with glue. Ideally, this would have used a special clip after being inserted into a thin faceplate but glue worked well enough.
Adding glue to the laser emitter
No infrared receiver was attached to the front of the tagger but everything else was connected to give an idea of what the tagger will look like from the front.
Business end of a tagger
Downloads:
- Arduino firmware
- OpenSCAD code
- STL printable models
- STL printable pipe dividers
- Python Last-Man-Standing program
The rest of the posts for this project have been arranged by date
First time here?
Completed projects from year 1
Completed projects from year 2
Completed projects from year 3
Disclaimer for http://24hourengineer.blogspot.com/ and 24hourengineer.com
This disclaimer must be intact and whole. This disclaimer must be included if a project is distributed.
All information in this blog, or linked by this blog, are not to be taken as advice or solicitation. Anyone attempting to replicate, in whole or in part, is responsible for the outcome and procedure. Any loss of functionality, money, property or similar, is the responsibility of those involved in the replication.
All digital communication regarding the email address 24hourengineer@gmail.com becomes the intellectual property of Brian McEvoy. Any information contained within these messages may be distributed or retained at the discretion of Brian McEvoy. Any email sent to this address, or any email account owned by Brian McEvoy, cannot be used to claim property or assets.
Comments to the blog may be utilized or erased at the discretion of the owner. No one posting may claim property or assets based on a post.
This blog, including pictures and text, is copyright to Brian McEvoy.
2017-05-28 (Su)
Comments
Post a Comment