Some of the components were changed, most notably the infrared sensor which was changed to reflect the footprint. This one has a silkscreen graphic which isn't so large which previously caused overlapping. During the change, the pins were also scrambled so that had to be reorganized.
Routing was done and boards were ordered. Graphics were generated to show to show the top and bottom as they will be built and the editor appearance. Since the board is symmetrical, the holes don't seem to change position in the graphic but the bottom doesn't have any surface-mount components, ie, the capacitor and resistor.
Downloads:
The rest of the posts for this project have been arranged by date
First time here?
Completed projects from year 1
Completed projects from year 2
Completed projects from year 3
Disclaimer for http://24hourengineer.blogspot.com/ and 24hourengineer.com
This disclaimer must be intact and whole. This disclaimer must be included if a project is distributed.
All information in this blog, or linked by this blog, are not to be taken as advice or solicitation. Anyone attempting to replicate, in whole or in part, is responsible for the outcome and procedure. Any loss of functionality, money, property or similar, is the responsibility of those involved in the replication.
All digital communication regarding the email address 24hourengineer@gmail.com becomes the intellectual property of Brian McEvoy. Any information contained within these messages may be distributed or retained at the discretion of Brian McEvoy. Any email sent to this address, or any email account owned by Brian McEvoy, cannot be used to claim property or assets.
Comments to the blog may be utilized or erased at the discretion of the owner. No one posting may claim property or assets based on a post.
This blog, including pictures and text, is copyright to Brian McEvoy.
2017-06-19 (M)
Layout with proper pins
Routing was done and boards were ordered. Graphics were generated to show to show the top and bottom as they will be built and the editor appearance. Since the board is symmetrical, the holes don't seem to change position in the graphic but the bottom doesn't have any surface-mount components, ie, the capacitor and resistor.
View of board
Downloads:
- Arduino firmware
- OpenSCAD code
- STL printable models
- STL printable pipe dividers
- Python Last-Man-Standing program
The rest of the posts for this project have been arranged by date
First time here?
Completed projects from year 1
Completed projects from year 2
Completed projects from year 3
Disclaimer for http://24hourengineer.blogspot.com/ and 24hourengineer.com
This disclaimer must be intact and whole. This disclaimer must be included if a project is distributed.
All information in this blog, or linked by this blog, are not to be taken as advice or solicitation. Anyone attempting to replicate, in whole or in part, is responsible for the outcome and procedure. Any loss of functionality, money, property or similar, is the responsibility of those involved in the replication.
All digital communication regarding the email address 24hourengineer@gmail.com becomes the intellectual property of Brian McEvoy. Any information contained within these messages may be distributed or retained at the discretion of Brian McEvoy. Any email sent to this address, or any email account owned by Brian McEvoy, cannot be used to claim property or assets.
Comments to the blog may be utilized or erased at the discretion of the owner. No one posting may claim property or assets based on a post.
This blog, including pictures and text, is copyright to Brian McEvoy.
2017-06-19 (M)
Comments
Post a Comment