Pictures from yesterday's measuring and drilling were taken in order to make a diagram of the hole sizes and positions. Measurements were taken from the top and bottom of the pipe so that there isn't any conflict with making the pipe longer.
The bottom of the tagger had two areas mapped off for the foregrip and handle. These were going to be attached with glue but since the pipe and prints are both ABS it should be possible to use ABS cement to chemically weld them together and create a strong bond. ABS cement may also be useful for repairing printed parts if they become damaged during use.
Downloads:
The rest of the posts for this project have been arranged by date
First time here?
Completed projects from year 1
Completed projects from year 2
Completed projects from year 3
Disclaimer for http://24hourengineer.blogspot.com/ and 24hourengineer.com
This disclaimer must be intact and whole. This disclaimer must be included if a project is distributed.
All information in this blog, or linked by this blog, are not to be taken as advice or solicitation. Anyone attempting to replicate, in whole or in part, is responsible for the outcome and procedure. Any loss of functionality, money, property or similar, is the responsibility of those involved in the replication.
All digital communication regarding the email address 24hourengineer@gmail.com becomes the intellectual property of Brian McEvoy. Any information contained within these messages may be distributed or retained at the discretion of Brian McEvoy. Any email sent to this address, or any email account owned by Brian McEvoy, cannot be used to claim property or assets.
Comments to the blog may be utilized or erased at the discretion of the owner. No one posting may claim property or assets based on a post.
This blog, including pictures and text, is copyright to Brian McEvoy.
2017-07-05 (W)
Measurements for holes on the top of the tagger
The bottom of the tagger had two areas mapped off for the foregrip and handle. These were going to be attached with glue but since the pipe and prints are both ABS it should be possible to use ABS cement to chemically weld them together and create a strong bond. ABS cement may also be useful for repairing printed parts if they become damaged during use.
Measurements for holes and pads on the botom of the tagger
Downloads:
- Arduino firmware
- OpenSCAD code
- STL printable models
- STL printable pipe dividers
- Python Last-Man-Standing program
The rest of the posts for this project have been arranged by date
First time here?
Completed projects from year 1
Completed projects from year 2
Completed projects from year 3
Disclaimer for http://24hourengineer.blogspot.com/ and 24hourengineer.com
This disclaimer must be intact and whole. This disclaimer must be included if a project is distributed.
All information in this blog, or linked by this blog, are not to be taken as advice or solicitation. Anyone attempting to replicate, in whole or in part, is responsible for the outcome and procedure. Any loss of functionality, money, property or similar, is the responsibility of those involved in the replication.
All digital communication regarding the email address 24hourengineer@gmail.com becomes the intellectual property of Brian McEvoy. Any information contained within these messages may be distributed or retained at the discretion of Brian McEvoy. Any email sent to this address, or any email account owned by Brian McEvoy, cannot be used to claim property or assets.
Comments to the blog may be utilized or erased at the discretion of the owner. No one posting may claim property or assets based on a post.
This blog, including pictures and text, is copyright to Brian McEvoy.
2017-07-05 (W)
Comments
Post a Comment