There were not enough pipes for all the parts that had been printed and purchased. It would have been possible to simply build fewer taggers but it seemed logical to have spares and enough pipes for all the parts. A five foot (1.5m) length of ABS pipe was purchased and cut into four equally sized pieces. Masking tape was applied to each side so the center lines could be marked. This time, the TOP and BOTTOM were clearly labeled along with the FRONT and REAR.
The hole locations were marked with a marker and the hole diameter was written on the tape. At the ends where the handle and foregrip were going to be cemented, a knife was used to score the plastic. After the tape is removed, that line can be used to attach the handle and foregrip in line with the tagger. The holes were drilled, some as large as 30mm across and all the tape was removed.
Downloads:
The rest of the posts for this project have been arranged by date
First time here?
Completed projects from year 1
Completed projects from year 2
Completed projects from year 3
Disclaimer for http://24hourengineer.blogspot.com/ and 24hourengineer.com
This disclaimer must be intact and whole. This disclaimer must be included if a project is distributed.
All information in this blog, or linked by this blog, is not to be taken as advice or solicitation. Anyone attempting to replicate, in whole or in part, is responsible for the outcome and procedure. Any loss of functionality, money, property or similar, is the responsibility of those involved in the replication.
All digital communication regarding the email address 24hourengineer@gmail.com becomes the intellectual property of Brian McEvoy. Any information contained within these messages may be distributed or retained at the discretion of Brian McEvoy. Any email sent to this address, or any email account owned by Brian McEvoy, cannot be used to claim property or assets.
Comments to the blog may be utilized or erased at the discretion of the owner. No one posting may claim property or assets based on a post.
This blog, including pictures and text, is copyright to Brian McEvoy.
2017-08-09 (W)
Cut pipes with masking tape markings
The hole locations were marked with a marker and the hole diameter was written on the tape. At the ends where the handle and foregrip were going to be cemented, a knife was used to score the plastic. After the tape is removed, that line can be used to attach the handle and foregrip in line with the tagger. The holes were drilled, some as large as 30mm across and all the tape was removed.
Marking hole locations and center lines
Downloads:
- Arduino firmware
- OpenSCAD code
- STL printable models
- STL printable pipe dividers
- Python Last-Man-Standing program
- Gerber files for SMT IR Sensor board
- Gerber files for controller board
- Gerber files for homemade controller board (thicker traces than the previous version)
- Public project page for controller board
- Public project page for sensor board
The rest of the posts for this project have been arranged by date
First time here?
Completed projects from year 1
Completed projects from year 2
Completed projects from year 3
Disclaimer for http://24hourengineer.blogspot.com/ and 24hourengineer.com
This disclaimer must be intact and whole. This disclaimer must be included if a project is distributed.
All information in this blog, or linked by this blog, is not to be taken as advice or solicitation. Anyone attempting to replicate, in whole or in part, is responsible for the outcome and procedure. Any loss of functionality, money, property or similar, is the responsibility of those involved in the replication.
All digital communication regarding the email address 24hourengineer@gmail.com becomes the intellectual property of Brian McEvoy. Any information contained within these messages may be distributed or retained at the discretion of Brian McEvoy. Any email sent to this address, or any email account owned by Brian McEvoy, cannot be used to claim property or assets.
Comments to the blog may be utilized or erased at the discretion of the owner. No one posting may claim property or assets based on a post.
This blog, including pictures and text, is copyright to Brian McEvoy.
2017-08-09 (W)
Comments
Post a Comment