I had to desolder the power and data wires between the microcontroller board and the IMU module. They were stacked right on top of one another, but now they will be on the same plane. The holes didn't line up accurately, and the ones under the long Feather board were worse than the IMU. So far, I always have to scale up my prints to 105% because of something goofy in my printer, and that number isn't precise. There were a couple of other issues, like the battery compartment was too short, and there wasn't room for the wires coming out of the vibrator.
I revised my model with the changes, but in the printer software, I scaled the X and Y axes to 104% and the Z-axis to 150%. The massive Z-axis was so that my pockets would be deeper and the bottom thicker. All my components fit snugly, and their mounting holes lined up correctly. Even my vibrator motor snapped into place, and the wires hung out without any stress on them.
The rest of the posts for this project have been arranged by date.
Completed projects from year 1
Completed projects from year 2
Completed projects from year 3
Completed projects from year 4
Completed projects from year 5
Completed projects from year 6
Completed projects from year 7
Disclaimer for http://24hourengineer.blogspot.com and 24HourEngineer.com
This disclaimer must be intact and whole. This disclaimer must be included if a project is distributed.
All information on this blog, or linked by this blog, is not to be taken as advice or solicitation. Anyone attempting to replicate, in whole or in part, is responsible for the outcome and procedure. Any loss of functionality, money, property, or similar, is the responsibility of those involved in the replication.
All digital communication regarding the email address 24hourengineer@gmail.com becomes the intellectual property of Brian McEvoy. Any information contained within these messages may be distributed or retained at the discretion of Brian McEvoy. Any email sent to this address, or any email account owned by Brian McEvoy, cannot be used to claim property or assets.
Comments to the blog may be utilized or erased at the discretion of the owner. No one posting may claim property or assets based on their post.
I revised my model with the changes, but in the printer software, I scaled the X and Y axes to 104% and the Z-axis to 150%. The massive Z-axis was so that my pockets would be deeper and the bottom thicker. All my components fit snugly, and their mounting holes lined up correctly. Even my vibrator motor snapped into place, and the wires hung out without any stress on them.
Every component seated
GitHub repo for Cardinal, aka InCompass
Completed projects from year 1
Completed projects from year 2
Completed projects from year 3
Completed projects from year 4
Completed projects from year 5
Completed projects from year 6
Completed projects from year 7
Disclaimer for http://24hourengineer.blogspot.com and 24HourEngineer.com
This disclaimer must be intact and whole. This disclaimer must be included if a project is distributed.
All information on this blog, or linked by this blog, is not to be taken as advice or solicitation. Anyone attempting to replicate, in whole or in part, is responsible for the outcome and procedure. Any loss of functionality, money, property, or similar, is the responsibility of those involved in the replication.
All digital communication regarding the email address 24hourengineer@gmail.com becomes the intellectual property of Brian McEvoy. Any information contained within these messages may be distributed or retained at the discretion of Brian McEvoy. Any email sent to this address, or any email account owned by Brian McEvoy, cannot be used to claim property or assets.
Comments to the blog may be utilized or erased at the discretion of the owner. No one posting may claim property or assets based on their post.
This blog, including pictures and text, is copyright to Brian McEvoy.
2020-07-21
2020-07-21
Comments
Post a Comment